Threaded Mode | Linear Mode

Joshuam08 · (This post was last modified: 03-12-2010 09:39 PM by Joshuam08.)

I want to make 2 big walls around an area in y map, and it's too big for me to do each block individually. I tried using /a then /draw, but nothing happens. Does this software have a command to do big walls?

**Twdtwd** · 03-13-2010, 01:41 AM

/a then /draw should work fine.

Did you place the action blocks in the 2 far corners?

Did you place and not delete the action blocks?

If so did it give you an error?

Joshuam08 · 03-13-2010, 07:59 AM

I made a pillar to the top of the map, and then put 1 action block on ground level, then flew up to the top of the pillar, then I put another action block and did /draw. Am I supposed to do something else as well?

**Unison** · 03-13-2010, 09:03 AM

Were you placing air?

Joshuam08 · (This post was last modified: 03-13-2010 09:42 AM by Joshuam08.)

I don't know... I just used /draw and it said done so possibly... how do I place adminium for example?

Works now lol

**Unison** · 03-13-2010, 10:23 AM

Try doing this, on a the flat ground (think of it as downward view, from above):

- = air
+ = brick (action block)

-----+
------
------
+-----
(the older of the 2 should turn into lava, don't worry)

Then type /draw. Let me know how it goes.